Punch Recording

What is Punch Recording?

Punch Recording (sometimes called “Auto Punch”) is a method to let Mixbus automatically initiate recording during a part of the timeline.

A common usage of punch recording is the case of a person recording themselves, during an instrumental solo. The player would like to hear the audio playback up to the punch point, and then have Mixbus begin recording automatically when the solo section is reached.

How do I punch-record?

To enable punch recording, you must define a punch-range and enable the Punch In/Out buttons:

1. Pre select a time-range to record (example: the guitar solo) by dragging the mouse in Range mode.
2. Enable the punch markers by right clicking in the range and selecting “Set punch from selection” or by pressing the { key on your keyboard
3. Enable the Punch In/Out buttons in the transport toolbar. (If you don’t see these, you can enable them in Preferences->Appearance->Toolbar
4. arm the track(s) and the master record on the transport. As the transport rolls, recording will only occur as the playhead rolls over the defined area protecting existing audio before and after the range.

• If the “In” button is enabled, then Mixbus will initiate the transport Record-arm when the punch range is entered.
• If the “Out” button is enabled, then Mixbus will stop recording when the punch range is exited.

* It is a good idea to set your “punch” points slightly before and after the desired range; this way you will capture slightly more audio in case you start playing slightly early or late. You can trim the region(s) later.

Harrison Consoles Copyright Information 2023
No part of this publication may be copied, reproduced, transmitted, stored on a retrieval system, or translated into any language, in any form or by any means without the prior written consent of an authorized officer of Harrison Consoles, 750 Jim Parker Drive Smyrna, Tn 37167.