Metering

Meterbridge meters ( NOTE: these options only apply to the meters in the Meterbridge window )

Peak Hold Time

The hold time for the peak-hold indicators. Ranges from off to short, medium, and long.

DPM fall-off

The decay rate of audio meters, ranging from Off (instant decay) to Slowest (6.6dB/sec decay rate).

Meter line-up level; 0dBu

This selector configures the reference level for all meters configured as IEC1/Nordic, IEC2/PPM and VU meters.

IEC1/DIN Meter line-up level; 0dBu

This selector sets the reference level specifically for meters configured to IEC1/DIN standard.

VU Meter standard

This selector sets the 0 VU reference level for VU meters. Standard for recording is 0VU = +4 dBu. Broadcast applications typically use 0VU = +8 dBu.

Peak Indicator Threshhold (dBFS)

This slider allows you to set the threshold of the peak indicators.

Default Meter Types

These selectors allow you to separately specify what kind of metering algorithm is used for tracks, buses and the master bus. Several options are available for each.

Default Meter Type for Master Bus

Default Meter Type for Busses

Default Meter Type for Tracks

Region Analysis

Enable automatic analysis of audio

If this is enabled, Mixbus will always analyze audio (to find transients) when files are imported to a session. This might cause imports to take longer, but it saves time when you try to “skip to next transient”.

Harrison Consoles Copyright Information 2023
No part of this publication may be copied, reproduced, transmitted, stored on a retrieval system, or translated into any language, in any form or by any means without the prior written consent of an authorized officer of Harrison Consoles, 750 Jim Parker Drive Smyrna, Tn 37167.