Generate
This window controls Mixbus’ output of timecode (both LTC and MTC) , MIDI Machine Control commands, and the MIDI beat clock.
Linear Timecode (LTC) Generator
Enable LTC Generator
The checkbox enables the LTC generator. When enabled, Mixbus will send LTC from the LTC port. The LTC generator can be routed to an audio track using the routing tool.
Send LTC while stopped
When enabled Mixbus will continue to send LTC information even when the transport (playhead) is stopped. This checkbox is grayed out if “Enable LTC Generator” is not selected.
LTC generator level [dbfs]
The slider allows setting the level of the peak volume of the generated LTC signal in dBFS. A good value is 0 dBu^= -18 dBFS in an EBU calibrated system.
LTC Output Port
This selector will set a default output on the audio interface for the LTC signal, connected to this output when the session is opened. In the picture this session uses a 64-wide Dante interface, the LTC may be sent by default to any of these outputs.
MIDI Time Code (MTC) Generator
The checkbox enables the MIDI time code generator. A maximum limit on varispeed may be set.
MIDI Machine Control (MMC)
The checkbox enables Mixbus to send MMC commands. The MMC device ID is set here.
MIDI Beat Clock (MCLK) Generator
The checkbox enables the MIDI beat clock generator.
Post your comment on this topic.