Presonus Faderport (original)

Presonus Faderport

The Presonus Faderport is a one-channel controller with a single touch-sensitive motorized fader, pan knob, and transport controls. Mixbus has a special mode for the FaderPort which provides dedicated features for this hardware.

When attached, the Faderport follows the selected (red-bordered) channel. You can change the selection with the Faderport’s > and < buttons.

The Faderport has these controls:

• Fader
• Pan knob
• Mute / Solo / Rec-Arm
• Channel Select, including Output(*)
• Fader automation mode: Read, Write, Touch, Off
• Undo ( shift+Undo to redo )
• Punch : blinks when auto-punch (in or out) is enabled
• Transport Controls including Loop, Markers, and Goto Start/End, as shown.
• Mix, Proj, Trns, and User are user-assignable buttons, see below.
  

The “Bank” button is currently unused.

The Faderport’s control panel provides a means to assign functions to the various buttons:

*Clicking the “Output” button will cause the Faderport’s fader and mute to control the Master bus. Holding Shift+Output will cause the Faderport to control the MONITOR bus fader and mute.

*It is not currently possible to assign the Faderport to a VCA fader, but we expect to add this feature immediately after v4.0.

Remote-control protocols are largely developed by the Ardour open-source community, and you can find documentation about the FaderPort on the Ardour website: http://manual.ardour.org/using-control-surfaces/Presonus_FaderPort/

Harrison Consoles Copyright Information 2023
No part of this publication may be copied, reproduced, transmitted, stored on a retrieval system, or translated into any language, in any form or by any means without the prior written consent of an authorized officer of Harrison Consoles, 750 Jim Parker Drive Smyrna, Tn 37167.